Integrated Engineering-PCV Solution Kit-2.0T FSI
Save your engine from an oily mess, built-up crankcase pressure, rough idle, fuel economy, and boost loss with a quick and simple install that takes less than 20 minutes on average. You will immediately notice a drastic improvement in drivability and power if your valve was leaking previously.
One of the most common failures on the 2.0T FSI engine is the factory pressure-relief valve. These valves are in place to recirculate crankcase gases into the intake manifold once they open. Although this works fine for a few thousand miles, they begin to leak over time and cause boost to go past the valve into the valve cover. This not only causes an oily mess in the engine bay from crankcase pressure, but a rough idle, fuel economy decline and boost loss. With boost pressure far below where it should be, it is common to notice significant power losses and poor drivability.
Using IE's kit, you are able to completely remove the pressure-relief valve and replace it with a billet aluminum plate. This allows the factory breather system to function properly, while eliminating the failure-prone relief valve. With the hose between the valve cover and intake manifold completely eliminated, the included boost cap is used to block off the hose connection on the end of the intake manifold. Our billet cap features a tapped hole that can be plugged or used to plumb a boost gauge, compared to competitors products that do not offer a provision for plumbing a boost gauge.
Installation of this kit is very straightforward and takes less than 20 minutes. You will immediately notice a drastic improvement in drivability and power if your valve was leaking previously.
Direct replacement for factory pressure-relief valve
Quick and simple installation
IE boost cap offers provision for plumbing boost gauge
Bright black anodized finish
Fits all timing belt-driven 2.0T FSI engines including:
Audi - TT 2008-2015 (MK2 - 8J) 2.0T FSI (EA113) engines*
Audi - TTS 2008-2015 (MK2 - 8J) 2.0T FSI (EA113) engines
*NOTE: IE PCV Solution Kits only work on early model 2.0T EA113 engines. You can verify you have the correct engine if it is in the above chassis and is driven by a timing belt. If your engine is driven by a timing chain, you have an EA888 Gen1/Gen2 TSI engine and is not compatible with this product.